1.8 KiB
petwifi
An ESP8266 expansion for the Commodore PET / CBM.
Unlike the C64, the Commodore PET does not have a serial port. For that reason, most serial port adapters for the C64 don't work, and an alternate interface must be found. Furthermore, the user port on the PET doesn't supply any power, so an external power supply would be necessary.
There is hope, however: The cassette port supplies 5V power and has suitable logic lines that can be used to emulate a serial port.
The drawback is that serial communication must be fully emulated in software.
Due to the different voltage levels of the ESP8266 and the PET, some voltage conversion is necessary. Luckily, this can be achieved with minimal circuitry: Converting from 5V to 3.3V can be done with a resistor divider. For the opposite direction, no conversion is necessary, because the voltage swing from 3.3V CMOS output drivers is sufficient to drive NMOS input gates.
Special care must be taken for the MOTOR control line (which is used as CTS control input on the ESP): It is driven by a darlington array on a 9V supply rail.
The other pin mappings are as follows:
| PET pin | ESP pin | Direction | Internal connection |
|---|---|---|---|
| Cassette Write | RXD | PET->ESP | VIA PB3 |
| Cassette Read | TXD | ESP->PET | PIA1 CA1 |
| Cassette Motor | CTS | PET->ESP | PIA1 CB2 |
| Cassette Sense | RTS | ESP->PET | PIA PA4 |
A suitable serial signal (RS-232-like) must be generated/decoded in software. Make sure that no cassette port #1 access is generated while the adapter is connected.
For programming info, refer to this excellent document: http://www.6502.org/users/andre/petindex/local/pet-io-2.txt