63 lines
2 KiB
Markdown
63 lines
2 KiB
Markdown
# Crap-Connect 2030
|
|
|
|
A DIY Tag-Connect adapter that doesn't drain your bank account. Some assembly required.
|
|
|
|
## BOM
|
|
|
|
* 2x PCB (see `tagconnect` KiCad project folder)
|
|
* 6x pogo pins with ca. 1mm outer diameter, sufficiently thin tip
|
|
* 3x metal rods with ca. 1mm diameter used as alignment pins (e.g. long pin headers)
|
|
* 1x pin header 2x3, 2.54mm spacing
|
|
* Shrinkwrap
|
|
|
|
## Assembly
|
|
|
|
1. Put the pogo pins into one of the PCBs. I've found a small hammer and some support on the oder side (`X`) to be useful; something like this:
|
|
|
|
| Hit here with hammer
|
|
V
|
|
|
|
| | |
|
|
| | |
|
|
===========
|
|
XX | | | XX
|
|
XX | | | XX
|
|
XX | | | XX
|
|
XX | | | XX
|
|
XX | | | XX <- this side is the tips of the pogo pins
|
|
XX XX
|
|
1. Repeat for the second PCB:
|
|
|
|
| Hit here with hammer
|
|
V
|
|
|
|
| | |
|
|
| | |
|
|
===========
|
|
| | |
|
|
| | |
|
|
===========
|
|
XX | | | XX
|
|
XX | | | XX <- this side is the tips of the pogo pins
|
|
XX XX
|
|
XX XX
|
|
XX XX
|
|
XX XX
|
|
1. Make sure the tips of the pogo pins are able to move freely.
|
|
1. Solder the pogo pins into place. Make sure to not get solder in between the pins, it's close to impossible to get clean again.
|
|
1. Put the alignment pins (`I`) in their appropriate holes. Use the hammer if necessary. Should look something like this:
|
|
|
|
| | |
|
|
I | | | I
|
|
===========
|
|
I | | | I
|
|
I | | | I
|
|
===========
|
|
I | | | I
|
|
I | | | I <- this side is the tips of the pogo pins
|
|
I I
|
|
1. Solder the alignment pins into place.
|
|
1. Solder the 2x3 pin header directly to the tail ends of the pogo pins. By now, the whole thing should look somewhat like this:
|
|
![Almost completed Crap-Connect](img/crapconnect1.jpg)
|
|
1. Wrap in shrinkwrak and you're done:
|
|
![Almost completed Crap-Connect](img/crapconnect2.jpg)
|